Preparing the Camera-Ready Paper for Proceedings of 
VII International Conference M&MS 2024
Viktor Palagin1, Boris Malik2, Vladyslav Yevsieiv1 
1. CITAR Department, Kharkiv National University of Radio Electronics, UKRAINE,
Kharkiv, Nauki Ave. 14., e-mail: vladyslav.yevsieiv@nure.ua
2. Faculty ACT, Kharkiv National University of Radio Electronics, UKRAINE, Kharkiv, Nauki Ave. 14.
 e-mail: borys.malyk@nure.ua

	Abstract: In this paper the instructions for preparing camera-ready paper for International Conference M&MS 2024 are given.
	Keywords: camera-ready paper, VIII International Conferences, M&MS 2024.
I. Introduction
	In order to achieve a required quality of M&MS 2024 Conference Proceedings the authors are requested to follow instructions given in this sample paper. 
II. Instruction for Authors
	The length of each submitted paper must be from 3 to 5 full pages. A title of the paper must be written using 22 pt font, centered. The spacing between a title and authors line is 6 mm. Author's names (without affiliation) should be typed using 14 pt font. Author's affiliation (institution, address, email) should be given at the bottom of the first column using 9 pt font.
	Times New Roman 10 pt font should be used for normal text. The normal line spacing is 1.5 times of the font size. Please equalize the length of the columns on the last page. Paragraph should be indented 3.5 mm.
	Manuscript have to be prepared in two columns separated by 5 mm. The margins for A4 (210x297) are given in Table 1.
TABLE 1. Page layout description
Paper size	А4	
Left margin	15mm	
Right margin	15mm	
Top margin	20mm	
Bottom margin	34mm	
Column spacing	5mm	
	At the beginning of the paper the abstract and keywords should be given. Abstract should be about 50 words. It is desirable to have up to 5 keywords. Please use 9 pt bold font for abstract and keywords and 9 pt italic for the words "Abstract" and "Keywords" followed by semicolon.
	A text of the paper is divided into several sections. The section titles should be typed using 12 pt font in Small Caps Option. For numbering use Roman number. The space after section and between the last section and the next section title are 5 mm.
	The formulas and equations should be centered and numbered, referenced in the text. Please use Word Equation Editor to present your formulas. Larger equations have to be divided into multiple lines. A typical example of equation is shown in Eq. 1:
.	(1)
	All tables should be made in MS Word editor Tables must have title located above the table. Table captions should be written using 9pt by Times New Roman font.
	Figure are placed to text, numbered, and commented by bottom text, as to example at Fig.1

Fig.1. Drawing explanations

	The figure size should not be greater than page (column) size. Figure must be of high quality. The figure should be commented by explanation of graphical and text notations and aligned by center. Every introduced figure is referenced in the main text.
	The references to literature sources are numerated by order of their reference in the text of thesis and identified by numbers in square brackets. For example [1], [1, 2], [1-4].

III. Conclusion
	In this paper the instructions for preparing camera-ready paper for including in the Proceedings of VIII International Conference M&MS 2024 are given. The document, prepared by author, must be submitted using current instructions. Authors are responsible for the content of presented materials.  

References
[1] P. B. Johns, "A symmetrical condensed node for the TLM method," IEEE Trans. Microwave Theory Tech., vol. MTT-35, pp.370-377, Apr. 2017.
[2] V. Trenkic, C. Christopoulos, and T.M. Benson, "Efficient computational algorithms for TLM," in 1st Int. Workshop TLM, Univ. Victoria, Canada, Aug. 2015, pp. 77-80.